What is PD IEC/PAS 63083-SAR measurement procedure for LTE devices about?
PD IEC/PAS 63083 is a European standard that discusses the specific absorption rate (SAR) measurement procedures for long term evolution (LTE) devices to ensure that they are within the safety guidelines.
PD IEC/PAS 63083 applies to measurement procedures of SSAR generated by devices with LTE technology specified by 3rd Generation Partnership Project (3GPP), Rel. 8 and 9 [1] where the devices are intended to be used with the radiating part near the human head and body.
PD IEC/PAS 63083 supports both FDD and TDD modes. The objective of PD IEC/PAS 63083 is to
define the number of test conditions concerning basic radio frequency aspects, i.e., channel bandwidths, number and offset of allocated resource blocks (RB), modulation, and maximum power reduction (MPR) for IEC 62209-1 and IEC 62209-2.
Who is PD IEC/PAS 63083-SAR measurement procedure for LTE devices for?
PD IEC/PAS 63083 on the SAR measurement procedure for LTE devices is useful for:
- LTE device manufacturers
- LTE device test personnel
- Occupational safety and health departments
- Risk assessment departments
Why should you use PD IEC/PAS 63083-SAR measurement procedure for LTE devices?
LTE technology shows an added complexity over previously available radio schemes and in
order to configure and test LTE devices, many signal parameters must be taken into account. The combinations of parameters in each frequency band can result in hundreds of
LTE Modes and SAR test configurations. The main purpose of this protocol is to support the
demonstration of DUT compliance with applicable exposure limits based on several reasonable SAR evaluations.
PD IEC/PAS 63083 provides you with the protocol for SAR assessment, general LTE SAR testing considerations, description of LTE Mode selection, uncertainty estimation, measurement report, and much more.
The procedure provided by PD IEC/PAS 63083 assists you in improving the performance of the LTE device and ensuring protection from radiation hazards.
With obedience and compliance to PD IEC/PAS 63083, you can enhance the efficacy of the LTE device and manufacture a standardized product.
