What is PD IEC/TR 62002-3 - Measurement interface for DVB-T/H radio access about?
PD IEC/TR 62002-3, which is a Technical Report, defines the minimum requirements for a terminal measurement interface to be used in test systems which is designed to verify the terminal conformance according to IEC 62002-1 and IEC 62002-2.
The interface described in PD IEC/TR 62002-3, is specially designed for use with terminal category c), hand-held portable convergence terminals.
The measurement interface in accordance with PD IEC/TR 62002-3, is used to control the terminal and read the degradation information from the terminal.
Note: The test signal interface (terminal input) is specified in the IEC 62002-2 and is not part of PD IEC/TR 62002-3.
Who is PD IEC/TR 62002-3 - Measurement interface for DVB-T/H radio access for?
PD IEC/TR 62002-3 on Measurement interface for DVB-T/H radio access is useful for:
- Manufacturers of mobile and portable DVB-T/H radio devices
- Product design engineers / innovation teams
- Testing and quality control personnel
- Broadcasters
- Compliance / health and safety authorities
Why should you use PD IEC/TR 62002-3 - Measurement interface for DVB-T/H radio access?
PD IEC/TR 62002-3 is about the measurement interface for mobile and portable DVB-T/H radio access.
PD IEC/TR 62002-3 allows the test system to:
- Control the terminal so that it is set to the different operating modes and frequencies required by the conformance test procedures
- Read degradation information from the terminal
The terminal also outputs additional useful information, e.g., signal strength, modulation parameters etc. This information is used in other measurements like field tests.
The terminal supports one of the following measurement methods:
- Manual measurement
- Test system-controlled measurement
Although a manual measurement mode is included in PD IEC/TR 62002-3, the main purpose of PD IEC/TR 62002-3 is to describe the interface to be used in an automatic test system, where the test system controls the terminal and reads the measured values from the terminal.
PD IEC/TR 62002-3 describes the t the measurement interface for mobile and portable DVB-T/H radio access, which contributes towards users getting access to high-quality reception for devices.
