PD IEC TS 63297:2021

What is PD IEC TS 63297 about?

PD IEC TS 63297 provides the classification of NILM sensing devices for use in NILM systems, according to the state of the art of NILM technologies. The classification of NILM analytics and NILM systems, as well as performance indicators for NILM systems, can be considered in the future. NILM systems produce estimated disaggregation into energy usages. When accurate measurement and analysis of energy consumption and/or other electrical parameter is needed (e.g., for monitoring the electrical installation), systems based on standardized measuring devices (e.g., PMD, PQI, or meters) are used.

NOTE: Standardized measuring devices have guaranteed accuracy over a specified range and have limited deviations in presence of influence quantities (temperature, frequency deviations, etc.) in addition to safety and constructional requirements.

Who is PD IEC TS 63297 for?

PD IEC TS 63297 on non-intrusive load monitoring (NILM) systems is beneficial for:

• Electrical engineers
• Electricians and people working in the electrical department
• Manufacturers and distributors of sensing devices for NILM systems
• Maintenance Electricians

Why should you use PD IEC TS 63297?

Non-intrusive load monitoring (NILM), or non-intrusive appliance and load monitoring (NIALM), is a process for providing estimated energy usage, e.g., by type of use (heating, cooling, etc.) or type of appliance (microwave, etc.) based on load signatures at a single point in the installation.

PD IEC TS 63297 can be used to survey the specific uses of electrical power in homes, buildings or industrial areas. PD IEC TS 63297 is essentially used in AC distribution networks, but DC networks are not excluded.

PD IEC TS 63297 depicts the value of an electrical parameter (e.g., current, power, energy-related to a specific usage) produced by a NILM sensing device or a NILM system.